Sp flash tool v3.1304
![sp flash tool v3.1304 sp flash tool v3.1304](https://s3.manualzz.com/store/data/023457932_1-f65d52f2b8d90a7756c0ffd202594b3d.png)
In this state, the Flash Tool does not close the COM port, and trying to restart any operation by reconnecting the device will cause an error. When after the red strip pass to 100% as a result of the firmware, Operation buttons are again available for clicking, but no error message, no green circle, this error appears, or similar to it, the code of which is 1013. The port was visible, it was selected in the Flash Tool settings, the program recorded it in the INI file, after which the system was rebooted with the port disabled, and immediately launched the Flash Tool without selecting the port. Theoretically, it can occur in the USB UART mode. If the USB port of the computer is faulty, then it is necessary to puncture the cable to another port.
![sp flash tool v3.1304 sp flash tool v3.1304](https://i2.wp.com/www.bypassfrpfiles.com/wp-content/uploads/2021/05/Redmi-FRP-10.jpg)
Here on this page, we have shared the official and tested version of SP Flash Tool, i.e., SP Flash Tool v3.1304. The problem can be in the USB cable, in this case, replace the cable. SP Flash Tool v3.1304 is a small application for Windows Computer, which allows you to Flash or installs the Stock Firmware on devices powered by MediaTek Chipset.
SP FLASH TOOL V3.1304 INSTALL
It also allows you to flash or install the Custom Recovery (CWM/TWRP), Boot File, and remove the Factory Reset Protection (FRP) from the. In this case, you will not see the equipment on which the PRELOADER drivers are placed. SP Flash Tool allows you to flash or install the Scatter Based Stock Firmware (ROM) on devices powered by MediaTek Chipset, whether a smartphone, Tablet or a Feature Phone. Even if the COM port is virtual, and the physical USB. For example, an error may occur if COM ports are disabled in the BIOS.